How to change your motorcycle oil step by step (and how often)
How often it is due, which oil your bike needs (watch the JASO rating) and the ten steps to change it at home without getting in a muddle: it is the best-value maintenance job there is.
Written by Andrés Rendón
Founder and host of Somos Motor, June 11, 2026
To change your motorcycle oil you need to warm the engine up for a couple of minutes, stand the bike upright, drain the old oil through the sump plug, change the filter, refill with the oil the manual calls for and check the level. It takes between 20 and 40 minutes and it is the best-value maintenance job there is: it costs little and does more than anything else to extend the life of the engine. Here is the complete guide: how often it is due, which oil to choose and the ten steps, without getting in a muddle.
01How often should you change motorcycle oil?
The short answer: whatever your bike's manual says, because each manufacturer sets its own interval and that is the one that counts. As a reference, most road bikes call for a change every 5,000 to 10,000 km, or once a year even if you haven't covered that distance. A 125 cc urban scooter may ask for it every 5,000 km, while a modern adventure bike on synthetic oil can stretch to 10,000 or 12,000.
Time counts as much as kilometres: oil degrades even if the bike is sitting in the garage, because it absorbs moisture and oxidises. If you ride few kilometres, change it every season anyway. And if you use the bike in town, with lots of cold starts and stop-start riding, shorten the interval: that kind of use is harder on the oil than the open road.
02Which oil does your bike need (and why car oil won't do)?
Three details define the right oil, and all three are in your manual:
- The viscosity (for example 10W-40 or 15W-50): it is the oil's "thickness" when cold and when hot. Using a different one from what your bike asks for means poor lubrication. If you are torn between two numbers, we explain what 10W40 viscosity means compared with 15W50.
- The JASO rating: this is the key that separates motorcycle oil from car oil. Bikes with a wet clutch (most of those with gears) call for JASO MA or MA2; scooters whose transmission is separate from the engine may call for JASO MB.
- The type: mineral, semi-synthetic or fully synthetic. The more demanding the bike (higher revs, more power), the more synthetic makes sense.
That is why the golden rule is simple: car oil does not go in a motorcycle unless the manufacturer expressly allows it. Many bikes share the engine oil with the clutch, and car oils contain friction-reducing additives that make it slip. We go into it in why car oil can ruin your clutch.
03What do you need to change the oil at home?
Before you start, gather all the equipment. Working halfway through with a part still to buy is a recipe for disaster.
- New oil with the viscosity and JASO specification from the manual, in the right quantity. A 125 cc scooter usually takes just over a litre; a naked bike or mid-size adventure bike, between 2.5 and 3.5 litres; and some large twins ask for up to 4. The exact figure, with or without the filter, is in the manual.
- A new oil filter. Some brands call for one at every change and others every second one; if you cover few kilometres a year, always change it, because it costs little and stops the new oil getting dirty as it passes through a clogged filter.
- A new washer for the drain plug, copper or aluminium and almost always single-use. It is the great forgotten item: if you reuse the old, already deformed one, you will get leaks at the sump plug.
- A spanner or socket the size of the plug (it varies by model) and, if the filter is a screw-on cartridge, an oil filter wrench.
- A torque wrench, to tighten to the correct torque.
- A drain tray of at least 3 or 4 litres, and an empty container to take the used oil to the recycling centre.
- Funnel, nitrile gloves and rags.

04How do you change motorcycle oil step by step?
- Warm the engine for 3 or 4 minutes. Warm oil flows better and carries more dirt out with it. Don't bring it up to full operating temperature: warm is enough, and that way you won't burn yourself touching the sump.
- Stand the bike upright and level, on the centre stand or a rear paddock stand. With the side stand the draining is incomplete and the level reading afterwards comes out wrong.
- Locate the two plugs: the drain plug at the bottom of the sump and the filler cap at the top. Put the tray underneath.
- Open the filler cap first, so that air gets in and the oil drains better, then loosen the drain plug with the spanner. Take it out carefully: the oil comes out hot.
- Let it drain for at least 10 minutes, until only drops fall. Clean the plug, fit the new washer and tighten it with the torque wrench to the figure in the manual: on many bikes it is around 20 to 30 Nm, but your manual rules. Neither loose (leak) nor overtightened (damaged sump thread, an expensive repair).
- Change the filter. If it is a screw-on cartridge, undo it with the filter wrench (a little more oil will come out), smear the new one's seal with a little clean oil and tighten it by hand plus an extra quarter turn. If it is an internal cartridge, open the cover, replace the filter element and change its O-ring.
- Refill through the filler cap, little by little and with a funnel. Put in about 80% of the quantity in the manual, wait a minute and check.
- Measure the level with the bike upright: by sight glass or by dipstick, depending on the model (with the dipstick resting in place without screwing it in, if the manufacturer says so). It should sit between minimum and maximum.
- Start it for 30 seconds, switch off, wait a couple of minutes and measure again. Top up if needed, without going over the maximum.
- Check for leaks at the plug and the filter.

05What should you do with the used oil?
Never pour it down the drain, put it in the bin or tip it on the ground: it is a polluting waste. Oil doesn't dissolve in water, it forms a film that blocks oxygen, which is why a single litre does so much harm in a river or the sewers. Keep it in a sealed container and take it to a recycling centre or a garage. The used filter also goes to the recycling centre, not in the household rubbish. In Spain there is an integrated used-oil management system (SIGAUS) so that it ends up recycled.

06Typical mistakes that put the engine under strain
- Overfilling. Too much oil causes foaming and high pressures, and can damage the seals. More is not better.
- Not changing the filter, or doing it without thinking: the new oil gets dirty quickly if the old filter is still full of residue.
- Overtightening the plug. You strip the sump thread, and repairing a thread costs more than many oil changes.
- Reusing the plug washer. If it is deformed, a leak is certain.
- Checking the level with the bike leaning. The reading is false and you end up with too much or too little oil.
- Using car oil in a bike with a wet clutch: the clutch slips.
07Is it worth doing it at home or taking it to a garage?
Do it yourself if the bike is easy to work on, you have the basic tools and somewhere to work: you save on labour, which varies a lot from one garage to another (we look at it in how much a garage charges per hour), and the risk is low if you respect the tightening torques. Go to a garage in four cases. If the bike is under warranty, because the stamp in the service book protects your cover. If you don't feel confident with the torque wrench. If the filter or the plug are in an impossible position, as on some sports bikes with full fairings. Or if your bike calls for a valve clearance check or another service that falls due at the same interval. A good garage will also spot leaks or wear that you might miss. If you are torn between a main dealer and an independent, here is the comparison.

Oil doesn't travel alone: the same weekend you change it, it is worth looking at the chain, the brake pads and the battery.
This guide is part of our complete motorcycle maintenance guide, where you will find everything you need to check and how often.
Frequently asked questions
How often should motorcycle oil be changed?
Whatever your manual says. As a guide, most road bikes call for a change every 5,000 to 10,000 km or once a year, whichever comes first. In urban use, with lots of cold starts, it is worth shortening the interval.
Can I use car oil in my motorcycle?
Not in bikes with a wet clutch (most bikes with gears). Car oils contain friction-reducing additives that make a wet clutch slip. Always use an oil with a JASO MA or MA2 certification. Scooters with a transmission separate from the engine can take JASO MB, but the right thing is to follow the manual for your model.
How much oil does a motorcycle take?
It depends on the model. A 125 cc scooter usually takes between 0.8 and 1.2 litres; a mid-size naked or adventure bike, between 2.5 and 3.5 litres; and some large twins can take up to 4 litres. The exact figure, distinguishing between a change with or without a filter, is in the manual. Always put in 80% at first and adjust using the sight glass.
Do I have to change the oil filter at every oil change?
It depends on the manufacturer: some brands call for it at every change and others every second one. Changing only the oil and not the filter isn't ideal, because the old filter is full of residue and quickly dirties the new oil. If you cover few kilometres a year, always change it: it is cheap and makes a difference. Confirm the interval in the manual for your model.
Should the engine be hot or cold?
Warm. A couple of minutes running is enough for the oil to flow better and carry more dirt out with it, without any risk of burning yourself. To check the level, wait a minute after switching off.
What happens if I don't change the oil on time?
Degraded oil loses its lubricating and cooling ability. Wear on pistons, bearings and camshaft increases, temperatures rise and sludge forms that blocks oilways. In the short term you will notice more mechanical noise and higher consumption; in the long term, expensive failures such as seizing or premature clutch wear. Changing it on schedule is the best-value investment in maintenance.
Keep reading
More from the blog
November 9, 2026
Tyre checks before a long journey, and when to replace them
Before a long drive, check tyre pressure when the tyres are cold, using the figure for your load, and make sure the tread is above the 1.6 mm legal minimum.
November 9, 2026
Car maintenance checklist: what to check, how often and what you can do yourself
Oil and filters, tyres, brakes, coolant, battery, timing belt and the MOT: what needs checking, how often, which jobs you can do at home and which belong in a garage.
November 7, 2026
Car battery in winter: why it fails and how to test it
In the cold, a 12 V battery delivers less current just when the engine demands most to start, and it exposes the wear summer left behind. Which signs warn you, how to measure it with a multimeter, what changes with start-stop and how to avoid being stranded.