Skip to content
We Are Motor
Blog November 9, 2026 4 min read

Tyre checks before a long journey, and when to replace them

Before a long drive, check tyre pressure when the tyres are cold, using the figure for your load, and make sure the tread is above the 1.6 mm legal minimum.

Neumáticos nuevos y coche en un taller de neumáticos

Written by Dautos Car

Tyres and everyday mechanics in Marbella, November 9, 2026

Tyres are the only part of the car that touches the road, and checking them takes a few minutes. Before a long journey, or before loading the boot full, look at three things: pressure, tread and age. Facts checked on 11 November 2026.

01What to check before you set off

Pressure comes first, and it is measured with the tyres cold. The Highway Code says tyres must be correctly inflated to the vehicle manufacturer's specification for the load being carried, and that you should check weekly and before a journey, with the tyres cold, because warm or hot tyres may give a misleading reading. As you drive, a tyre warms and its pressure rises, so a reading taken after a long run will look higher than it really is.

Find the right figures in the handbook, and often also on a sticker in the door frame or inside the fuel flap. Manufacturers usually give a figure for normal use and a higher one for a full load, so use the loaded figure if you are carrying passengers and luggage. A pocket gauge in the glovebox is cheap and means you are not relying on a garage forecourt machine. If your car has a tyre pressure monitoring system, it still pays to measure by hand now and then.

Look at the sidewalls and the tread too. The Highway Code says excessive or uneven wear may point to braking or suspension faults, or wheels out of alignment, and should be corrected as soon as possible. Cuts, bulges and objects stuck in the tread are reasons to get the tyre looked at by a specialist before you go.

New tyres and a car in a tyre fitting workshop
Dautos Car

Do not forget the spare, if you carry one: a tyre loses air slowly even when it is not in use, and you do not want to find out at the roadside.

02What pressure with a loaded car?

Use the manufacturer's figure for the load you are carrying, as above. It is not a matter of guesswork or of letting some air out because the weather is hot: the handbook figure is set for a cold tyre and already allows for the tyre warming up in use.

03When should you replace them rather than push your luck?

Replace them before the tread reaches 1.6 mm, which is the legal minimum for cars. The Highway Code says cars, light vans and light trailers must have at least 1.6 mm across the central three-quarters of the breadth of the tread and around the entire circumference. The same rule is set out in the Road Vehicles (Construction and Use) Regulations 1986.

Many professionals advise changing earlier. Pirelli notes that traction and stopping power fall noticeably between 3 mm and the legal limit, and that many tyre professionals now suggest replacing at 3 mm. Either way, the 1.6 mm figure is the floor, not a target.

A 20p coin is a quick home check. Pirelli describes the band around its edge as roughly 2 mm: put the coin in a main groove, and if you can see any part of that outer band, the tyre needs replacing. Check several points around the tyre. A pass does not tell you whether you have reached 3 mm. Michelin adds that once the tread reaches the wear indicators in the grooves, which mark the legal limit, it is time to change the tyre.

New tyres and a car in a tyre fitting workshop
Dautos Car

Age counts even when the tread looks good. Michelin recommends replacing tyres as a precaution once they are 10 years from their date of manufacture, and says the same applies to spares. The date is in the DOT code on the sidewall: the last four digits give the week and year, as we explain in our guide to reading a tyre. For correct inflation step by step, see our tyre pressure guide.

04Quick checklist before you leave

Before a journey, check the tyres' pressure, tread and age.

  1. Pressure, measured cold, using the manufacturer's figure for the load you are carrying.
  2. Tread, comfortably above 1.6 mm and ideally with a margin, and sidewalls free of cuts and bulges.
  3. Age, from the date of manufacture on the sidewall.

If they look due for replacement, go to a trusted tyre fitter and ask them to confirm what you have seen here: cold pressure with the loaded figure, tread depth and date of manufacture.

Frequently asked questions

What is the legal minimum tyre tread depth in the UK?

For cars, the Highway Code says at least 1.6 mm across the central three-quarters of the breadth of the tread and around the whole circumference.

When should I check my tyre pressures?

Weekly and before a journey, with the tyres cold, according to the Highway Code. Warm or hot tyres may give a misleading reading.

How old is too old for a tyre?

There is no general legal age limit for cars, but Michelin recommends replacing tyres as a precaution once they are 10 years from their date of manufacture.

Email alerts

We will alert you about this section

We will alert you about all sections Change

Sections

Turn on notifications

The day before, the time of every session and where to watch it.