Skip to content
We Are Motor
Blog August 24, 2026 5 min read

Soft, medium and hard tyres in F1: why they matter

The soft grips more but lasts less; the hard is the opposite. What the colours mean, why they force pit stops and how they decide who wins in Formula 1.

Monoplaza de Fórmula 1 rodando con neumáticos de banda roja

Written by Andrés Rendón

Founder and host of Somos Motor, August 24, 2026

Soft, medium and hard tyres in Formula 1 are three versions of the same dry tyre with a different rubber compound. The soft grips more and goes faster, but wears out sooner; the hard grips less and is slightly slower per lap, but lasts many more laps. The medium sits in the middle. That difference between speed and durability is what forces each team to plan when to come into the pits to change tyres.

01Why is a soft tyre faster but shorter-lived?

It is the same principle as a soft rubber eraser versus a hard one. The soft one rubs out better because it sticks to the paper, but wears away quickly; the hard one lasts much longer, but rubs out less well. It is the same with a racing tyre: a soft compound heats up sooner and sticks more to the asphalt, which gives more grip and faster laps. In return, that rubber wears away quickly and loses performance within a few laps.

The compound is the recipe of the rubber: the mix of materials that decides whether it is softer or harder. The softer it is, the more instant grip and the shorter the life. The harder it is, the less grip but much more resistance to wear. No tyre is better than another: there is the right one for each situation.

02What do the colours of F1 tyres mean?

The colours are a visual code on the sidewall of the tyre so that spectators can see at a glance which rubber each car is running. Formula 1's sole supplier paints them like this for both the dry and the wet compounds.

CompoundSidewall colourGripDurabilityWhen it is used
SoftRedMaximumLowQualifying, short stints, attacking
MediumYellowMediumMediumThe balance, much of the race
HardWhiteLowerHighLong stints, managing
IntermediateGreenDamp trackVariableLight rain or the track drying out
Full wetBlueWaterlogged trackVariableHeavy rain, lots of water

A stint is each run of laps that a car does on the same set of tyres before stopping to change them. Softs are for short, fast stints; hards, for stretching the run as far as possible.

Formula 1 car running on tyres with a red band
Foto: Steve (CC BY-SA 2.0).

03Are there only three compounds in Formula 1?

No. The supplier makes a wider range of dry compounds numbered from hardest to softest, and for each Grand Prix it picks three from that range for that particular circuit. Those three selected are simply called soft, medium and hard for that weekend, although from one circuit to another the physical compound behind the colour changes.

That is why the soft at a fast, abrasive circuit may be a different rubber from the soft at a slow circuit. The name (soft, medium, hard) is relative to that Grand Prix's selection, not to a fixed compound. That range of dry compounds is usually numbered from C1, the hardest, to C5, the softest, and from there the supplier chooses the three for each circuit.

Besides the dry tyres there are the two wet-weather tyres: the intermediate (green), for a damp or drying track, and the full wet (blue), for a waterlogged track with lots of water. These have tread (grooves that clear the water), whereas the dry ones are smooth, the famous slicks.

04Why do tyres force pit stops?

Because no dry compound lasts the whole race at its best. As the rubber wears, the car loses grip and gets slower lap after lap. There comes a point when it is worth losing around twenty seconds in the pits to fit fresh rubber, because the new tyres make up the time easily on the following laps.

That is where strategy is born, which is the tactical heart of Formula 1. Each team decides how many stops to make, on which lap and on which compound the car goes out afterwards. It is not the same to gamble with two sets of softs and attack as to go one-stop on hards and hold on. A race is often won or lost at the strategy table, not just on the track.

05Is it compulsory to use two different compounds in a race?

Yes, in dry Grands Prix. The sporting regulations require each driver to use at least two different dry compounds during the race. You cannot do the whole Grand Prix on a single type of rubber. This forces at least one pit stop and stops everyone running the same way from start to finish.

Note: this requirement applies only to Grands Prix. In sprint races, the shorter races held on some weekends, there is NO rule about using two compounds, so a driver can complete the sprint on a single type of rubber.

The rule also changes if it rains and the race is run on wet-weather tyres (intermediates or full wets): in that case the requirement to use two dry compounds lapses, because conditions take over. This two-compound rule is precisely what turns the choice of tyres into a game of chess rather than a simple question of who is quickest.

Formula 1 car running on tyres with a red band
Foto: Heimo Ruschitz (CC BY-SA 2.0).

06How does a team choose between soft, medium and hard?

It depends on the circuit, the asphalt temperature, how much the track punishes the tyres and the pit stop strategy they want. On a layout that wears tyres heavily, you tend to see more use of the medium and the hard; on a smooth or cold one, the soft can hold up well and give a clear advantage.

Temperature is key: each compound has an operating window, a temperature range in which it really performs. If the tyre is cold, it does not grip; if it overheats, it degrades suddenly. Part of the driver's and the engineer's job is to keep the rubber within that window for as long as possible.

The rest of the vocabulary of a broadcast, from the undercut to porpoising, is in the F1 glossary with 30 terms. And if you are missing the basics of how the championship works, you have them in how Formula 1 works.

On the Somos Motor podcast we talk about this kind of detail from the world of motorsport with professionals who live competition up close. If you want to keep learning to understand what really happens in a race, sign up for the newsletter and do not miss a thing.

Frequently asked questions

What is the difference between a soft and a hard tyre in F1?

The soft (red sidewall) has more grip and sets faster laps, but wears out in a few laps. The hard (white sidewall) grips less and is slightly slower per lap, but lasts many more laps. The medium (yellow) is the balance between the two. The choice depends on whether you want speed or durability.

What colours are Formula 1 tyres?

In the dry: red for the soft, yellow for the medium and white for the hard. For the wet: green for the intermediate (damp track) and blue for the full wet (waterlogged track). The colour is painted on the sidewall so spectators can see at a glance which rubber each car is running.

Why do F1 cars stop to change tyres?

Because the rubber wears and the car loses grip and speed lap after lap. There comes a point when stopping for around twenty seconds to fit fresh tyres pays off, since the new ones make up that time on the following laps. In addition, the rules require two different dry compounds to be used, which forces at least one stop.

Is it compulsory to change compound in an F1 race?

Yes, in dry Grands Prix each driver must use at least two different dry compounds during the race. You cannot run the whole Grand Prix on a single type of rubber. This rule does NOT apply to sprint races, which can be completed on a single compound. And if the race is run in the wet on intermediates or full wets, the two-dry-compound requirement no longer applies.

Email alerts

We will alert you about this section

We will alert you about all sections Change

Sections

Turn on notifications

The day before, the time of every session and where to watch it.